SilverSilk Findings 3-Strand Pinch End Caps - Gold Plated 12x12mm
Free shipping Australia wide
SilverSilk Findings. 3-Strand Pinch End Caps For SilverSilk Capture. Gold Plated 12x12mm. Quantity: 2 Pieces. Used in this video tutorial:. How to Use SilverSilk Pinch End Caps and Make a Bracelet. . These end caps are specially designed to finish three strands of SilverSilk Capture chain. There is an attached, closed loop ready for attaching clasps or rings. Finish: Gold plating over brass. Measurements: 12mm long, 12mm wide and 4mm thick. The attached ring is 4mm in diameter and 19 gauge thick. Quantity: 2 Pieces Instructions For Attaching Capture End Caps: 1) Cut the end of the SilverSilk Capture with a flush cutter 2) Pinch the end and roll it between your fingers to wrap the outer knitted wire around the end of the bead chain. 3) Make sure your end cap is open wide enough to fit the chain. Place the end of the Capture all the way into the open end cap so that there is a round bead sitting each square compartment. 4) Use a nylon jaw plier to squeeze the end cap completely closed. There should be no open space along the sides. Tip: Before finishing the other end of the strand, run your pinched fingers over it while holding the finished end to tighten the knitted wire before cutting.