Part I Steam Turbine Cycles and Cycle Design Optimization 1.
Introduction to steam turbines for power plants 2. Steam turbine
cycles and cycle design optimization: the Rankine cycle, thermal
power cycles, and IGCC power plants 3. Steam turbine cycles and
cycle design optimization: advanced ultra-supercritical thermal
power plants and nuclear power plants 4. Steam turbine cycles and
cycle design optimization: combined cycle power plants 5. Steam
turbine life cycle cost evaluations and comparison with other power
systems
Part II Steam Turbine Analysis, Measurement and Monitoring for
Design Optimization 6. Design and analysis for aerodynamic
efficiency enhancement of steam turbines 7. Steam turbine rotor
design and rotor dynamics analysis 8. Steam turbine design for
load-following capability and highlyefficient partial operation 9.
Analysis and design of wet-steam stages 10. Solid particle erosion
analysis and protection design for steam turbines 11. Steam turbine
monitoring technology, validation, and verification tests for power
plants
Part III Development of Materials, Blades and Important 12.
Development in materials for ultra-supercritical (USC) and advanced
ultra-supercritical (A-USC) steam turbines 13. Development of
last-stage long blades for steam turbines 14. Introduction of new
sealing technologies for steam turbines 15. Introduction of
advanced technologies for steam turbine bearings 16. Manufacturing
technologies for key steam turbine parts
Part IV Turbine Retrofitting and Advanced Applications in Power
Generation 17. Steam turbine retrofitting for the life extension of
power plants 18. Steam turbine retrofitting for power increase and
efficiency enhancement 19. Advanced geothermal steam turbines 20.
Steam turbines for solar thermal and other renewable energies 21.
Advanced ultra-supercritical pressure (A-USC) steam turbines and
their combination with carbon capture and storage systems (CCS) 22.
Steam turbine roles and necessary technologies for stabilization of
the electricity grid in the renewable energy era 23. Conclusions
Tadashi Tanuma is a Professor at Teikyo University, Japan. He is
the head of the Laboratory of Fluid-Structural Simulation and
Design in the Strategic Innovation and Research Center. He also
works for the Graduate School of Science & Engineering and the
Department of Mechanical and Precision System Engineering in Teikyo
University.
Professor Tadashi Tanuma began his career as a development
mechanical engineer in 1980 at Turbine Factory, Toshiba
Corporation, Japan. He led the Turbomachinary Development Group
from 1993. Subsequently, he joined the Steam Turbine Design
Department in Keihin Product Operations of Toshiba Corporation. He
developed and designed Toshiba 52-inch last stage long blade for
nuclear power steam turbines and steel 40 and 48-inch last stage
long blade for thermal power steam turbines as an aerodynamic
engineer and led many research and development programs for steam
and gas turbine efficiency enhancement technologies. He was the
President of the Gas Turbine Society of Japan (2015).
Ask a Question About this Product More... |